I am having a problem with grid snapping in block diagrams
When a new block is added to the drawing, I can connect to the connectors via a cable or dogleg with no problems, however, it seems that these connectors are just slightly off grid. What can I do about this? It causes drawings to look a little funny when the attachment point is almost on the grid, but not quite.
Thank you for your help in resolving this quickly.
I am currently using English Units of measurement for the grid spacing.
Jerry Nuckolls
Acoustics Engineer
I
The attachment shows the problem that I am encountering.
Upon a fresh install, it seems to work as it should for approximately 10 drawings.