I am currently under an extremely tight time crunch and have to have drawings over to a customer and architect by this afternoon.  My apologies if this subject was already discussed in the past but I surely do not have time to go searching through topics to find the answer...

When I have a stardraw drawing up (ie panel layout) and I do a "save as" into a CAD (.dwg) format, sometimes the symbols are not pulling over correctly when I open them in CAD.. especially being the XLR panel connectors.  There are circles missing, etc.  On some of the other ones, they are absolultely fine.  This is sometimes happening within the same drawing as well.  The connector can look great on one panel but totally missing lines on another panel.  Again, I have to get these over to the customer here right away this afternoon and it looks embarrassing.  Please any assistance right away would be greatly appreciated.

Thanks Again!

Jon