Hi,

I am creating some new products for a project, have created block  schematics (easy) and have created front and rear view of the product.
Have repeated this on another product (similar but not the same).

Suddenly, when either using the ppriduct in a rack schematics or if I try to edit symbol, everything is upside down.
I tried to delete all lines and symbols in the symbol editor and redo this, it's still upside down when I try to use it.

What have I done wrong?

A follow up question:
This product is a small box, 100x40 mm in front/rear view, so we mount them 4 side by side on a rack shelf.
I can insert 4 products side by side in front view and it will be ok in rear view, but You get a strange thing in side view.
Depending on the sideway position in front (or rear view), You get a different position in side view.

Is this a "feature" so all products on the same vertical level will be displayed in the side view, so You see that there is say 4 units, or is this something else ?
Normally we use the side view to show where the product in located in the rack, at the front side, the rear side.

With kind regards
Mats