Hey Team,

I use the available symbols section in the drawings as a useful tool when running between, pictorials, schematics, racks etc to ensure all items are covered and there is almost a nice sense of achievement once you have pulled all items out of the area to service your drawings knowing its been attended to in every required instance.

However, whenever you create multiples of the same drawing type, the available items list is 'whole' and you can see all possible items as available to insert into this new drawing. It would be a useful feature to allow you to mark an item as 'used' or similar? perhaps using the Products tab where it shows what items have been used in what drawings. I.e. Perhaps by default a symbol can only appear in one drawing type in a project, and if it appears in a schematic already it is not shown as available for another schematic, unless you access the Products tab and tick the drawing against the symbol to allow it to be used on that new drawing?

Hope the above makes sense

Cheers

Alan