By Bman - 11/10/2019 10:05:54 AM
I installed the latest update to the 7.3 this morning - and have been running around my entire plan correcting cables and placings - somhow, ALL the user defined products became smaller
As the screen shot below shows, not only did the UDP get smaller (the 1 on top is what I got when I deleted the device from the drawing and dragged it back in from the Available Symbols pane) - but the alignment to the grid is off on almost all the UDP the are on the drawing (I actually think on ALL) - so even if I was done moving things around, I would have had to sort the whole drawing out. Cable liines were all over the place in respect to the grid.
What's going on??
|
By Rob Robinson - 11/10/2019 4:07:08 PM
Hi Bman,
Thanks for your post. The recent update will have had no effect on UDPs or drawings - no changes have been made in that area. For details of the update see http://forums.stardraw.com/Topic18448.aspx
Can you send your project file to techsupport@stardraw.com, so that we can see exactly what's happening in that project, as well as a screengrab of the whole screen so that we can see your current Document Properties Grid settings?.Thanks.
|
By Rob Robinson - 11/10/2019 5:09:31 PM
Hi Binyamin,
Thanks for sending the project file and screengrab. It appears that the whole of the drawing was scaled up by 130% - which is why things are off the grid and larger when compared to new symbols added from the Product Browser - so the correct fix will be to scale the drawing back down by 100/130 (76.923%).
I hope this is helpful.
|
|