Hi there,

Whenever I put in a new line connecting products, the label will overlap the product and I have to manually set it where I want. Is there a way to have to "snap" to the correct location on creation? I see there's a section to modify the starting location though couldn't seem to get it perfect.
Thanks!

I assume you are using a Cable Preset and it sounds like you may have changed the Label Offset values.

The Label Offset default values are:
Start Label
     X = 0.5mm
     Y = 0mm
Middle Label
  X = 0mm
  Y = 0mm
End Label
  X = -0.5mm
  Y = 0mm

Kind regards,
Rob Robinson
Stardraw.com